With
our TMT-WP18W-L18 you receive a perfect
computer-controlled powersaving LED lighting system
for your terrarium with any length from 60-90cm.
The installation is realised in less than 5 minutes. Even
if you want to replace your old energy-waisting
T8 or T5 lighting system this is achieved in a few
minutes. Simply open the cover, remove the old one completely
from your terrarium set and install the new one, close the
cover - finished!

With
this new LED technology 90% of the used energy is
converted into light now. This means during the same
lightning achievment an energy saving of approx. 68%
is available. Also you get an extended life span
of up to 100.000 hours (approx. 15.2 years at daily 18 operating
hours).

With
that freely programmable daylight and moon simulation
your small world slides over to a gentle
sunrise (1) to the daylight, in order to reach at
noon the maximum daylight (2). Continuing
to a sunny afternoon into the evening
light (3) until finally after dawn (4)
the moon rises (5). Also you may program
any 30-stage simulation by the included remote
control.

With
the included remote control you can control
all channels individually in 10% steps (0-100%) or stepless
(453nm & cool white 6500K). Also you can switch on and
off daylight automatic as well as programm the time. Please
see here, which set is the right one for your terrarium. Visit
our illumination guidebook.

Extendable
assembly clip for individual adjustment of terrariums of 60-90cm.

Full
aluminium housing. Further
sizes and models here.

Each
ground system (controler+LED bar) can be upgraded with an
additional LED bar. All necessary interfaces are provided
in the ground system. You only need one additional LED bar.
You
will find the additional bars here.

If
you do not want to install the system in the cover
you will find the matching clips/clamps here.

If
you need a extension cable, you find it in our shop.
2
meters and/or 5
meters
